• In terminal screws the wires are attached to screws inside the plug body. To replace:
  • Unscrew and remove the new plug’s insulating barrier.
  • Using a utility knife, split the end of the cord to separate the wires.
  • Push the cord through the plug body.
  • Make two loops with the wires.
  • Pass the loose ends of the wires through the loops and pull tightly to form an Underwriter’s knot (this prevents strain on the terminal screws.)
  • Strip 1/2 to 3/4 inch of insulation off the wire ends being careful not to nick the wires.
  • Unscrew the terminal screws on the barrier to allow space for the wires.
  • Form loops on each wire and wrap the wires clockwise 3/4 way around the screws.
  • Tighten the screws and trim the excess wire.
  • Reattach the barrier.